Ignitech Servo Cailbration

[4l04ever]

Hi All

Just helping setup an Ignitech on my mate's Aprilia YPVS. The servo seems to auto calibrate every time you switch the bike on, by going to maximum in open direction, then maximum in the closed direction, then goes to initial setting.

This does not seem ideal, as I don't like it forcing the servo motor to the stop in both directions. Is there a way to set the maximum and minimum servo positions and stopping this forcing the motor to it's physical stops? The Zeeltronic has a manual configuration where you set the fully closed and the fully open positions and then the servo only moves between these points.

Cheers

[muttsnuts]

yes, you set thge limits in the servo setting up screen, just set the lower limit at 0 rpm and the upper limit at max rpm or where you want it fully open and that is the max it will cycle between

[4l04ever]

Cheers

Will have another poke about... :-)