|
|
Post by zig on May 18, 2019 20:40:27 GMT 1
i purchased one of these kits from ebay and on inspection the pilot jet is 22.5...main is 220...and the needle float holder is marked 2.5,the one i removed from my carb isn't even marked,is that common or could it be an aftermarket piece?....has anyone run any of these sizes together?? should i give them al together a try,any ideas?
Also the carb slide needle is the same length but not the same taper , how would this effect the running? Overall the rest the pieces included are of really good quality and are an exact match eg length,size,thread ....i'm just a bit cautious to the 3 oversized jets so any advice appreciated
ZiG
|
|
|
|
Post by oldelsieboy on May 19, 2019 8:48:22 GMT 1
i purchased one of these kits from ebay and on inspection the pilot jet is 22.5...main is 220...and the needle float holder is marked 2.5,the one i removed from my carb isn't even marked,is that common or could it be an aftermarket piece?....has anyone run any of these sizes together?? should i give them al together a try,any ideas?
Also the carb slide needle is the same length but not the same taper , how would this effect the running? Overall the rest the pieces included are of really good quality and are an exact match eg length,size,thread ....i'm just a bit cautious to the 3 oversized jets so any advice appreciated
ZiG
The kit is for 4L0-01 (350LC) carbs not 4L1-00 (250LC) OEB |
|
