|
Post by marsbar350 on Jan 17, 2018 22:12:28 GMT 1
hi guys do these two use the same size head bearings
|
|
|
Post by dllc on Jan 25, 2018 19:53:03 GMT 1
no the 400s are much bigger od
|
|
|
Post by midlifecrisisrd on Jan 25, 2018 21:36:07 GMT 1
Just measure the stem at top and bottom then the headstock top and bottom
Then measure the depth of ypvs taper bearing and search for the size you need
If the bottom of the stem is too large for a bearing to fit the frame then your looking at a stem swap
Steve
|
|
|
Post by ozzysbikes on Jan 26, 2018 19:03:01 GMT 1
doesn't anyone know the bearings needed ? I am considering a similar set up as I have some spare ZXR 400 forks and I have seen this conversion done a few times, thing I was more unsure about was the ignition switch wiring and steering lock setup (making sure they both still work)
|
|
|
Post by dllc on Jan 26, 2018 19:36:51 GMT 1
u need to do a stem swap to get zxr yokes to fit an lc r pv. nigel in nk racing does it. i dont care about sterring lock so it doesnt work on mine. u would probably need some work done to top yoke for that. i think nigel sells his own custom topke yoke that keeps ignition and steering lock give him a shout
d
|
|
|
Post by ozzysbikes on Jan 26, 2018 19:38:16 GMT 1
Good info thanks d
|
|
|
Post by Tobyjugs on Jan 26, 2018 20:45:08 GMT 1
I do like the look of the top yoke on the ZXR's
|
|
|
Post by marsbar350 on Jan 26, 2018 20:49:33 GMT 1
ive sorted the bearing situation out thanks
|
|
|
Post by rich on Jan 27, 2018 15:36:18 GMT 1
ive sorted the bearing situation out thanks Care to share?
|
|
|
Post by marsbar350 on Jul 27, 2018 20:20:55 GMT 1
ive sorted the bearing situation out thanks Care to share? changed yoke for some custom made ones used standard balls and race at the top and roller at the bottom
|
|