|
Post by ftm73 on Jan 12, 2018 17:00:20 GMT 1
Hi everyone,
I recently removed my bellypan and the powervalve 2 piece clamp fell out! Unfortunately one of the castle type seals has also came loose, is it at all possible to refit this without taking the barrels etc off?
Thanks Sean
|
|
|
Post by midlifecrisisrd on Jan 12, 2018 17:07:19 GMT 1
If it worked it's way out I dare say you can get a new one in
Not saying it won't be fiddly though
Steve
|
|
|
Post by ftm73 on Jan 12, 2018 17:09:52 GMT 1
Cheers Steve,
Just so fekkin awkward to get into it tbh. Was wondering if there was a special tool or something that I could use to try and get it back in!
Sean
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 13, 2018 14:40:54 GMT 1
I removed mine before taking off the barrels
Fiddly but possible to do in reverse
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 13, 2018 14:41:29 GMT 1
I should mention you need to disconnect the PV cables first
|
|
|
Post by bare on Jan 17, 2018 1:33:23 GMT 1
Might be clever to give some thoughts as to: How? Why? that seal was expelled in the first place. Could be a Coked up mess in there.. or not. Should check it.. before something worse happens
|
|
|
Post by kostas on Jan 17, 2018 16:20:03 GMT 1
It is only the PV joining piece that holds the seal in place. With this removed the seal just blows out...
|
|
|
Post by ftm73 on Jan 19, 2018 11:18:20 GMT 1
Might be clever to give some thoughts as to: How? Why? that seal was expelled in the first place. Could be a Coked up mess in there.. or not. Should check it.. before something worse happens Thanks, I had the heads and barrels off back end of last year so no it's not a coked up mess in there. Unfortunately the clamp worked loose and I've had a seal come out. Regards Sean.
|
|