MK3 2HK engine needed!

[jimmy128]

Hi guys I am new to this forum!
I need a new engine for my MK3 rd125lc, as the engine that was running in it had a rusty bottom end and was a 10W anyway. If there are none available, what other engines would fit in it? Obviously the MK1 and MK2 engines, but what about a tzr engine or a modern dt engine? I will not be modding the frame to fit an engine.
I have seen plenty of 1GU barrels and heads on ebay so could I bolt one of them onto a 2HK bottom end?
Cheers

[jimmy128]

Oh yeah, a micron wouldnt be to bad either!

[museumman]

isnt your barrel a 1GU anyway on a 2HK motor ?

I have complete running 1GU engines for sale, I always have a thread on the for sale section on these boards .


 when it's time for a freshen up, just install everything into your original 2HK crankcases if you have them. If you only have the 10W bottom end and it had the square barrel fitted then the conrod will be too short and have different generator so forgot about it

[museumman]

these are my spare ones. They came from the same quality original bikes you see in my Avatar picture

The working power valve bits included make the price a lot higher

motor with generator starts at £290

[jimmy128]

Whats the price with all parts for a working power valve, and will i have the appropriate mounting points for them on a 2HK frame?

[museumman]

Yes all mk2s and mk3s have the servo mount from the factory, sent you pm with prices

[dpayne]

Pm sent museumman