Post by robadob on Jul 6, 2015 10:01:35 GMT 1
Got the flywheel puller sorted so thought Id see how far I can get on splitting the cases on the 125ypvs yesterday.
All went pretty well, some memories of doing it when i was a kid came trickling back and nothing sprung out as it all came apart but I do have a quick question.....or two!
When the cases came apart a couple of bits rolled onto the work bench and Im not sure where they go as I didnt see them in situ.
One was a ball bearing, same size and shape as the one that sits in the clutch shaft, does the clutch have one ball bearing each end or just the one??
The second is a dowel, smaller than the two dowels that locate the cases, same size as the two that fit between the barrel and the cases but Im sure it came from the gearbox end of the cases.
Cant find a spot for either of these!
Any engine Gurus know where these go?
All went pretty well, some memories of doing it when i was a kid came trickling back and nothing sprung out as it all came apart but I do have a quick question.....or two!
When the cases came apart a couple of bits rolled onto the work bench and Im not sure where they go as I didnt see them in situ.
One was a ball bearing, same size and shape as the one that sits in the clutch shaft, does the clutch have one ball bearing each end or just the one??
The second is a dowel, smaller than the two dowels that locate the cases, same size as the two that fit between the barrel and the cases but Im sure it came from the gearbox end of the cases.
Cant find a spot for either of these!
Any engine Gurus know where these go?
