kymbo
L plate rider.
Posts: 12
|
Post by kymbo on Sept 4, 2014 22:12:35 GMT 1
the power valves on my 500 have been giving me a bit of grief at the moment as they aren't doing the full cleaning cycle when the ignition is switched on , does anyone have any suggestions on how to go about freeing them without taking all the barrels off etc etc , thanks
|
|
|
Post by Bazille on Sept 6, 2014 9:59:29 GMT 1
doing them in situ is not possible theyre in two halfs, each removed from each side of barrel!
|
|
|
Post by jackjabba on Sept 6, 2014 10:29:10 GMT 1
Disconnect them and check by hand first, you may have a problem with the servo or controller. Had a problem with mine and it was a dodgy connector. Check the control rods as they can become worn and loose.
|
|