|
Post by woodentopp on Feb 16, 2012 20:05:13 GMT 1
I know this has been asked before and is perhaps a silly question, but....When you measure the gap for minimum stoke adjustment, Where do you measure?
I know it's under the washer, but against what? Any pic's/photo's gratefully accepted. ;D
|
|
|
Post by arrow on Feb 16, 2012 20:17:19 GMT 1
Here. Its a little raised area, and the only correct place to check the measurement. This pulley is off an aircooled 250 but the photo is still relavant; Attachments:
|
|
|
Post by woodentopp on Feb 16, 2012 20:49:08 GMT 1
Thanks
|
|