|
Post by JonW on Jun 29, 2020 8:23:39 GMT 1
Seem there are a few out there... Mitaka, Hinson and Chariot spring to mind. All cos of our close relation, the banshee.
Anything to make one choose one of these over the others?
And rubbers... Hinson do em, so do yambits... Are these the usual 'avoid yambits rubber parts' or are theirs sourced from someone trustworthy?
|
|
|
Post by headcoats on Jun 29, 2020 8:31:36 GMT 1
Mitaka seems OK and clutch rubbers from NK Racing Pretty sure the clutch rubbers were Wiesco too
|
|
|
Post by midlifecrisisrd on Jun 29, 2020 9:17:38 GMT 1
I've used mitaka with no problems
NK for my rubbers too
I was going to buy a Hinson 8 plate complete clutch but was put off when someone told me they had to dress the splines to get it to fit
I'm not paying over £600 to have to make it fit 😡
Steve
|
|
|
Post by peddrotzr on Jun 29, 2020 9:46:51 GMT 1
I had 2 Hinson baskets that I had to clean up the spines with a needle file so they would fit, far too tight on the spines, as they would only slide half way on the shaft. I might have just been unlucky with just one, but two! Both bikes work fine now since 2016.
|
|