|
|
Post by lisburnman on Dec 28, 2019 20:20:14 GMT 1
Finally got the fuel cap of and it worse than i imagined. Did a bit of poking at some lowere parts and near seams and if put a few small holes and pin holes. Not sure if its worth trying to repair and line it. Its a good looking tank apart from the rust ðŸ˜. Maybee some one will have a better one or good guidance for me thx    |
|
|
|
Post by steeley on Dec 28, 2019 20:45:31 GMT 1
|
|
|
|
Post by paulincayman on Jan 9, 2020 19:48:31 GMT 1
Save your efforts and enjoy the peace of mind of a new tank..
|
|
|
|
Post by steve h on Jan 9, 2020 22:51:27 GMT 1
Save your efforts and enjoy the peace of mind of a new tank.. +1 on that! |
|
|
|
Post by midlifecrisisrd on Jan 10, 2020 10:46:04 GMT 1
Change it
Paint is too expensive to ruin if it fails again
When I bought my hybrid donor it held fuel but if left on the side stand it sweated a bit on the left
Took it off and sat it up on its end and left it for 3 months
One day I noticed a 2 inch blister on the front lower edge so poked it with my finger
Went straight through the tank
Steve
|
|
|
|
Post by headcoats on Jan 10, 2020 10:49:33 GMT 1
Pity there isn't a process that can line the inside of the tank to seal it in
Don't think the liquid type sealers would do it
|
|
|
|
Post by yamman1066 on Jan 10, 2020 13:16:08 GMT 1
best to bin it and buy new
|
|
|
|
Post by JonW on Jan 15, 2020 0:27:54 GMT 1
buy a new one for sure!
|
|
