Post by Shytalk on Mar 30, 2017 18:13:40 GMT 1
I had some spare time this afternoon so decided to get a stator I have got lying around tidied up, the usual 4 pin plug has suffered from poor connections and the subsequent heat damage, plus the grommet was falling to pieces.
Replacement grommet sourced and I already had the pin removal tool for the connections
All the pins were removed, the connector blocks could then be cleaned up and the replacement grommet put on and a bit of heat shrink over the damaged bit of cable outer
After cleaning the parts the pins can be replaced into the correct plugs
The main plug was more of an issue as although I had got a replacement from Kojaycat on eBay the old and new internals are slightly different from each other and even after opening out the barbs on the pins they refused to lock in place
So I had to cut the old ones off and re crimp the supplied ones with the connector block, here's the finished article
Replacement grommet sourced and I already had the pin removal tool for the connections
All the pins were removed, the connector blocks could then be cleaned up and the replacement grommet put on and a bit of heat shrink over the damaged bit of cable outer
After cleaning the parts the pins can be replaced into the correct plugs
The main plug was more of an issue as although I had got a replacement from Kojaycat on eBay the old and new internals are slightly different from each other and even after opening out the barbs on the pins they refused to lock in place
So I had to cut the old ones off and re crimp the supplied ones with the connector block, here's the finished article
