|
barrel
Dec 18, 2011 22:00:21 GMT 1
Post by brian1111 on Dec 18, 2011 22:00:21 GMT 1
hi i have two sets of 250LC barrels and has you are sat on the bike both the left bores have some sort of square cut out on the exhaust port can anyone tell me how this as happened thanks bri Attachments:
|
|
|
barrel
Dec 18, 2011 22:22:59 GMT 1
Post by billy on Dec 18, 2011 22:22:59 GMT 1
It looks like it has had a seizure.
|
|
|
barrel
Dec 18, 2011 22:27:34 GMT 1
Post by pepsisteve on Dec 18, 2011 22:27:34 GMT 1
that looks like somebody has machined that into the cylinder
|
|
|
barrel
Dec 19, 2011 3:55:13 GMT 1
Post by bare on Dec 19, 2011 3:55:13 GMT 1
Regardless as to how..it's Eff'd find new cyls.
|
|
|
barrel
Dec 19, 2011 4:32:43 GMT 1
Post by billy on Dec 19, 2011 4:32:43 GMT 1
that looks like somebody has machined that into the cylinder It sure does, but I'd say it had a seizure. I've seen seizures very similar to that before, although I must admit in this case it looks surprisingly "well done" for being an engine failure lol.
|
|
|
barrel
Dec 19, 2011 13:13:45 GMT 1
Post by foxyjohn on Dec 19, 2011 13:13:45 GMT 1
Its wear caused by the piston rings
|
|
|
barrel
Dec 22, 2011 13:55:24 GMT 1
Post by Norbo on Dec 22, 2011 13:55:24 GMT 1
I think its a bit of both . Its had a piston ring make the damage at some point then its had some work carred out in an atempt to take of sharp edges and smoothit out a little ,
|
|